LD-COBWASH150TC
**************
The attached "GSD-file" should be programmed using our special "FIRMWARE UPDATER2+" unit (order code: B05019)

V1.14  (2021-10-14)
*******************
--> IMPORTANT: This is update is NOT NEEDED if your machine currently runs on V1.13 firmware! <--
This is an update to make sure that two different processor brands 
can be used during manufacturing, to overcome the current global shortage of electronic components.


V1.13  (2015-12-01)
*******************
Used from batch 1512
CHANGED
-When set LOCK=ON, lock the display immediately when power on.
-When set LOCK=ON, after each setting, press MODE for 2 seconds to lock the display immediately.


V1.12 + V1.11: NOT PUBLIC
*************************
IMPROVED
-When set LOCK=ON, lock the display immediately when power on.
-When set LOCK=ON, after each setting, press MODE+ENTER for 2 seconds to lock the display immediately.


V1.10  (2015-10-20)
*******************
BUGFIX: This update solves the problem where the setup menu is not locked during startup cycle (+/- 30seconds)
When the projector is used outdoor using an external clock to switch the projector on/off, raindrops could change the settings during the startup sequence.
This update makes sure that the setup menu is also locked during the startup sequence.
* When set LOCK=ON: press UP-DOWN-UP-DOWN-ENTER to unlock.
* After each setting, press MODE+ENTER for 2 seconds to lock the display immediately.

WWW.BRITEQ-LIGHTING.COM
(c)2015-2021

